Adjustment of edge twisting time and maintenance of electronic edge twister
The time when the upper and lower casual hemmings are in the same position is called hemming time. Depending on the characteristics of the weft yarn, the hemming time will be earlier or later. When the weft yarn is cotton yarn, the hemming time can be later, and when the weft yarn is elastic yarn, the hemming time should be earlier. During adjustment, the edge twisting device that takes the encoder signal can directly set the time for the edge twisting motor to start action on the panel. The edge-twisting device that takes the signal from the proximity switch should adjust the sending plate so that the proximity switch is just from not lit to bright (that is, the time when the edge-twisting motor starts to act). After adjustment, check the fabric surface to see if there is any shrinkage, otherwise it will need to be reset. The edge twister should be stored in a dry place, placed on its side in a specially designed small wooden box, and should not be squeezed to prevent bending. During use, pay attention to the wiring of electrical appliances to prevent interference. The gray hair and oil stains on the twisted heddles should be cleaned frequently. The slider moving up and down in the chute should be regularly dripped with a few drops of engine oil to ensure smooth flow.
AAADF3RSEGDTHIU
Extendedreading:https://www.alltextile.cn/product/product-87-89.html
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
ExtendedReading:
Extendedreading:
Extendedread
